It is essential that apple trees produce sufficient flowers to set an optimum crop of fruit in relation to the size of the trees. It is also vital that these flowers are of sufficient quality to set fruits reliably and to produce large fruits of good texture and storage potential.
On young newly-planted trees the objective is to induce quality flowers on the trees in the second and third years after planting i.e. to improve their floral precocity. If orchards are to break-even rapidly and move towards profitability on the investment, cropping early in the orchard’s life is essential.
On mature trees, lack of abundance of flowering is a relatively rare problem and usually only occurs with varieties that are prone to biennial bearing. Fortunately, most of the traditional varieties suffering from this problem (e.g. Miller’s Seedling, Laxton’s Superb) are no longer grown commercially, but Elstar can become strongly biennial in its cropping. The varieties Cox and Braeburn are weakly biennial. However, flower quality is often a limiting factor in fruit set and retention on mature trees.
Occasionally, excessive flowering and inadequate new extension growth may be a problem with some varieties grown on dwarfing rootstocks such as M.27 and M9 on replant soils. Here the objective must be to reduce the abundance of floral spurs and increase shoot growth, so as to bring the trees back into a more optimal balance of fruit production with shoot growth.
Flower initiation occurs early in the summer of the season prior to flowering and, during that season, many of the flower parts are formed. However, the final stages, which involve the formation of the pollen sacs and the ovules, do not occur until shortly before bloom in the subsequent spring. High quality flowers are essential if fruit set is to be achieved in the often less than ideal weather conditions at flowering time in UK orchards. Flower quality influences whether fruits are retained on trees throughout the season and also their size and quality at harvest.
Adequate floral abundance and good flower quality are essential considerations for both mature and young, immature trees. Flowering and fruiting on young apple trees in the second and third year is particularly vital if the investment in the orchard is to be economically viable.
Flowers on apple trees differ in their potential to set and retain fruits and these differences are usually referred to as differences in flower quality. Flower quality is the ability of a flower to set and carry a fruit. The most common measurement of flower quality is the Effective Pollination Period or EPP.
Types of flower buds
Spur buds: Formed on spurs and short terminal shoots. These begin their initiation shortly after fruit set in the preceding season.
Axillary buds: Formed in the lower (basal) leaf axils on extension shoots later in the season than spur buds, usually as shoot growth slows down in mid to late summer.
The aim must be to encourage the rapid production of high quality flowers on the spurs and short terminal shoots of young trees. Only with a few varieties, such as Gala and its sports, can axillary flowers be relied upon to contribute significantly to cropping on young trees. Even with Gala, axillary flowers are only useful if they are produced on strong wood of approximately 10 mm diameter.
Factors influencing flower quality
Anything that reduces the production of resources by the tree or diverts them away from the developing flower buds will reduce their quality. An imbalance of hormone levels in the tree will also affect flower bud development. The main factors influencing flower quality are:
If apple orchards are to prove profitable it is important that they begin cropping as soon as possible after planting (i.e. exhibit good yield precocity) and then rapidly build up cropping to high and consistent yield efficiencies in the succeeding years.
The yields in the first few years of the orchard’s life are vital if the investment is to prove viable. Investment appraisals using techniques of Discounted Cash Flows or Net Present Values highlight the importance of yields achieved in the first five years of an orchard’s life.
To achieve these yields in the first few years following planting it is essential that the trees produce adequate numbers of flowers and that these flowers are of sufficient quality to set and retain fruits through until harvest. This precocious cropping must not, however, be at the expense of the trees continuing to grow and fill their allotted space within the orchard. Balanced growth and cropping should be the aim in these early years following planting, as much as in the subsequent years.
When planning and planting young trees the importance and influence of the following should be considered:
The importance of planting well-feathered trees
Plant well-feathered trees with healthy, non-desiccated roots. Tree quality at the time of planting has a significant influence on how well the young trees establish and how quickly they begin to flower and fruit.
The onset of flowering is advanced and the abundance and quality of flowers improved if well-feathered trees are planted in good fertile soils.
Trees with 6 to 8 strong well-spaced feathers with wide branch angles should be chosen.
It is also important that these relatively large trees receive good water, nutrition and soil management to minimise the transplanting check to growth. Excessive transplanting check to growth will cause tree stunting and may lead to the production of branches with bare wood.
Post planting management
Trees planted in the autumn into deep, highly fertile soils with adequate supplies of water throughout the subsequent season should establish very well and make abundant shoot growth. When planting small or poorly feathered trees this response is desirable. However, where larger than average trees are planted, such conditions could result in excessive shoot growth and the production of fewer, poorer quality flowers in the second season following planting. Tree management after planting should aim to achieve balanced growth and precocious cropping.
Take steps to improve flower quality (i.e. ability to set fruits) on young trees. By being aware of the limitations on fruit set associated with poor flower quality on very young trees, it is possible to improve the situation by:
Ensure good tree establishment and avoid bare wood developing by:
Growers should obtain analyses of the soil mineral and organic matter contents prior to tree planting. Based on these analyses and the current recommendations concerning optimum levels (RB209) any necessary base dressings should be applied.
Supplementary nutrition of trees in their first or second years following planting have been shown to improve crop levels in intensive plantings of 2000+ trees per hectare.
Supplementary irrigation should be applied, preferably using trickle systems, when soil moisture deficits reach 50 mm.
Prevent stress to the trees (e.g. wind desiccation).
Prune and train trees so as to establish ideal balance of growth and flowering:
Use low doses of chemical growth regulators where necessary to achieve reduced shoot growth, improved balance of growth and improved fruit set.
Occasionally, insufficient flower numbers may be produced on varieties which are not usually prone to biennial bearing. This is usually the result of practices of tree management that lead to an imbalance between growth level and cropping.
Although, theoretically, trees should be able to produce sustained fruit production on a tree with a permanent spur system and minimal new shoot growth, many trials have shown that fruit size and quality slowly diminish on such trees.
Examples of this are trees planted on M.27 rootstocks, where insufficient renewal pruning is practised. Another example is trees producing no new shoot growth following excessive applications of growth regulators.
The first pre-requisite is to have some idea of the likely numbers of flowers developing on the apple trees. This assessment may be done pre bloom by dissection or in the orchard from blossom onwards.
Assess the correct numbers of fruit buds needed for an optimum crop
Take into account the variety, the growth habit of the trees and the cropping history. Assume 1 to 2 flower buds will be required to produce one harvested fruit. This is, however, dependent upon scion variety, tree vigour and site conditions
Cox, Bramley and Discovery
Gala, Jonagold, Egremont Russet, Braeburn, Jazz, Kanzi and Rubens
Increasing flower numbers on mature trees
Apple trees that are managed well should produce adequate numbers of quality flowers consistently from season to season. Where problems of insufficient flowering occur it is important to identify the cause of the problem and take the necessary remedial action. Where insufficient flowers are present it will be due to one or more of the following factors:
Poor flowering due to excessive vegetative growth
Where problems of excessive shoot growth and poor flowering on mature or semi-mature apple trees are experienced it is important to adapt pruning techniques in relation to the amount of fruit bud.
If the above adjustments to management practices prove inadequate and flowering is still insufficient growers can:
Consider girdling (bark ringing) of the trunk as a means of improving floral abundance and reducing excessive shoot growth. Care must be taken, however, when bark ringing varieties that are sensitive to diseases such as apple canker (Nectria galligena).
Consider root pruning down one side of the tree in November or in the early spring six weeks before bud burst. Specialist root pruning equipment should be used, placing the blade between 50 and 75cm from the trunk depending on the degree of growth control required. Ideally supplementary irrigation should be available in dry summers to avoid any possible reduction in fruit size.
Poor flowering due to lack of light into the tree canopy
A lack of light within the tree will reduce flower bud numbers and their quality. As shoots tend to grow strongly towards the light, further shading can be induced.
Light levels within the tree canopy can be improved by:
Poor flowering due to excessive cropping in the previous season
The number of seeds in the fruit produced in the previous season will have a major effect on the numbers of flowers formed. To reduce this effect growers should:
Overcoming biennial bearing
With varieties that have developed a biennial pattern of cropping growers should:
No chemical treatments, other than thinning treatments are approved for use against biennial bearing
Growers should strive to produce flowers of high quality with an Effective Pollination Period (EPP) of 3 days or more. For optimum flower bud quality:
Delaying flowering in the spring using plant growth regulators and other spray treatments
Pollination and fruit set are often reduced severely by spring frost damage to the flowers. One possible strategy that has been investigated in attempts to reduce this risk is delaying flowering in the spring using plant growth regulators or other spray treatments.